Frequency converters Series AE-L for the simple engineering systems

Description:
AE-L – designed specifically for OEMs who are looking for an economical and compact converter, providing easy operation.
Converters AE-L are available for motors from 0.75 to 2.2 kW at 220V. Adapted for use in the production of simple mechanisms. It has a built-in EMC filter, class B.
AE-L – ideally meets the requirements when the cost of commissioning, as well as the cost of using must be the lowest possible level.

Distinctive features:
The transmitter is immediately ready for use. Factory drive settings allow management to carry out at the first startup.
Electronic components provide long service life under normal conditions
Easier access to terminals
Resistance to the poor quality of power grids.

Management and communication:
Digital interface / protocol:
RS485 port (for connecting additional equipment is necessary)
Modbus (integrated)

Areas of use:

• The conveying equipment (small conveyors, etc.)
• Packing Equipment
• Pump and fan heaters
• Medical equipment
• Mechanisms for food processing (kneading machines, mixers, grinders)

Technical data:
– Rated input voltage (V) 1-phase 220-240V (± 10%) 50/60 Hz
– Output frequency range (Hz) 0.01 – 320 Hz
– Frequency accuracy – Digital setting: ± 0.01% of the maximum frequency, analog: ± 0.1% (25 ± 10 ° C)
– Frequency resolution Digital setting: 0.01Hz, analog setting: max. frequency / 1,000 / 1000
– Control method: PWM space vector modulation system
Characteristics of voltage / frequency
Volt. / Frequency control (constant torque, reduced torque), free volts / frequency control, Sensorless vector control
– Digital interface / protocol: RS485 port (for connecting additional equipment is necessary) / the Modbus (integrated)
– The overload capacity of 150% / 60 sec
– Starting torque 150% at 0.5 Hz
– Dynamic Braking (brief)
– Acceleration / deceleration time 0.1 ~ 3000. s (linear / non-linear setting the value)
– DC braking
– PID controller is integrated
– Removal of the control panel 1.5 – 3 meters through the use of the RS485 connection (RJ45), for connecting the organization require additional options.
– Analog input command
Input voltage: DC. DC 0 ~ + 10V (Input impedance 10 ohms) Input Current: 4 ~ 20mA (input impedance of 250 ohms)
– Digital output, relay output alarm relay operation in case of emergency chastotnika
Protection function: Over current, overload (electronic thermal), over-voltage, under-voltage, Communication error detection of external short circuit, unintentional start – error USP, EEPROM error, External error, ground fault, overheating, phase loss.

Optionally available: cable operator, braking resistor, AC reactor, DC reactor, EMC filters

– Ambient temperature: -10 … +40 ° C (+ 50 ° C with a load reduction)
– Dimensions HxWxD (mm) 140х83х95